Voltage Supply and Ground to Power StageBegin testing by checking the power stage. With the ignition off, disconnect the power stage harness connector. Connect a voltmeter to terminals 1 and 3 as shown in Fig. 3-11. When the ignition is turned on, there should be approximately battery voltage. Turn off the ignition. If there is no voltage, either there is a break in the wiring from terminal 1 to the fuse relay panel, or from terminal 3 to ground. Use the wiring diagrams in ELECTRICAL SYSTEM to check for continuity. Repair any wiring breaks as necessary, then reconnect the power stage connector.
|
|
Previous, Next, Contents, Home.